The Sweet Spring Kusudama is a very simple but very elegant looking origami kusudama, designed by Natalia Romanenko. Each unit is a combination of 2 or 3 smaller modules. Why do I say 2 or 3? Because, while the instructions I found online require 3 modules, you can make do with just 2 of them. 

The basic module is an origami pig base. This is formed from a square. To this module, we add 2 modules folded from a rectangle. This forms the star and a wavy loop on the star. Well, I didn't want the wavy bit, so I stopped with just the star. Hence had ended up with 2 instead of 3 modules. 

So once these units are assembled, the kusudama is formed by inserted 1 unit into the next. The assembly is very simple and the model holds well together. 

I have been meaning to use indigo coloured paper for a long time now, so I clubbed it with orange paper to give me a very bright sweet spring kusudama! 

Have you tried out this kusudama? Do give it a go, if you haven't. 

 

Model Details:

Model: Sweet Spring Kusudama

Creator: Natalia Romanenko

Difficulty Level: Low Intermediate

Paper Ratio: Square + Rectangle in ratio 1:2

Paper Size: 3 inches square / 3 inches by 1.5 inches rectangle

Model Size: ~4 inches in diameter

Modules: 60

Instructions: Paper Finger Cuts

Tutorial: Youtube

 

By far, my most professional attempt at my paper weaving projects, this orange and grey newspaper woven cup and saucer is my personal favourite. 

The tubes were actually part of my previous project - a coffee themed oval container. I loved the colour combination, so decided to make another project using the same. 

A lot of planning went into this set - from the way to start off and the method to interchange the colours, the reverse rope pattern in the centre, the edging of the saucer and also the cup - everything was planned. And I must say I am quite happy with the way it turned out. Specifically, I love the cross-pattern of the bottom and the beauty of the edging for both saucer and cup. 

To add durability to the handle, I ended up threading a wire through the 2 main anchoring tubes. So once I varnished it, the handle became incredibly strong. And overall, the cup can hold quite a bit of weight. 

I believe I have waxed eloquent about the project!! I do realise that the height is not even and this is my biggest problem. I am yet to figure out a way to maintain consistency, but I believe I will get there 😊