Palm Cross - Tutorial

With Palm Sunday tomorrow, these crosses made from palm leaves should come in handy, I hope :) So here is a quick tutorial to make a palm cross, in 10 simple steps..

Let's start. All we need is half a palm leaf, removed from the central vein and a pair of scissors.

1. Measure and cut the palm leaf to 20 inches. It helps if the size of the leaf is more or less the same throughout. So cut off the top bit, where the leaf narrows down and the bottom bit where it is quite thick, and cut out 20 inches from the remaining leaf.

2. Holding the leaf straight up, fold down the top half of the leaf at 10 inches from the bottom. Fold the leaf forward and ensure that it is perpendicular to the straight  bit.

3. Fold the bit from Step 2 around and behind the straight part of the leaf. The fold will now be in the opposite direction to the previous step.

3A. This is a close up of the folded corner.  You should be able to see the little right-angled triangle, formed from Steps 2 and 3.

4. Fold the arm in the right, again to the left, so that the right-angled triangle (Step 3A) is now hidden. Ensure that this fold is in the front and not behind the previous folds.

5. Now, make a small look (about 2 inches) and again fold to the right. This forms the first arm of the cross.

6. Repeat on the left, to get the second arm of the cross. But ensure that this fold is inbetween 2 layers. You should be near the end of the leaf now. So the last bit will go behind the fold in Step 5 and before the crease of Step 4.

6A. This gives the side view of the layers where the 2 arms of the cross meet. You can see the last bit of the leaf tucked inbetween 2 layers.

7. Almost there! Next, fold down all the layers (the 2 arms of the cross), so that the back of the cross is now seen. You should now be able to see a little square where the arms meet. Ensure that you do not let go of any of the layers here.

8. Now take the other end of the leaf and insert it into the square of the junction of the 2 arms. This might be tricky the first time. If you look into the little square, you will be able to see a little triangle (folded in Step 3). Now the leaf should be inserted above the triangle and below the square. This is the most crucial step that holds the cross together.

9. Slowly pull the end upwards completely. When it is fully through, it will lock the two arms in place. Now the difficult bits are over :)

10. Reinsert the long arm (now at the top), back into the square, as in the previous step. Pull it down slowly and stop when you have about 2 inches between the top and the square junction. This forms the 3 arm of the cross. The bottom bit is the fourth arm.

The cross is now complete :)

The two side arms can be adjusted, in case you feel they are not proportionate. And once you have completed the cross a couple of times, you can just eye-ball the length and finish off the cross in a jiffy..

Hope you have a blessed Palm Sunday.